Good Morning Nathan,
Thanks! What output lcio files are you looking at?
I'm not yet seeing any files on disk at
/work/hallb/hps/data/engrun2015/pass1/recon/
Norman
-----Original Message-----
From: [log in to unmask] [mailto:[log in to unmask]] On Behalf Of Nathan Baltzell
Sent: Tuesday, June 09, 2015 6:26 AM
To: hps-software
Subject: Re: pass1
Hello All,
Pass1 started with the calibration runs last night. Documentation is going here:
https://confluence.slac.stanford.edu/display/hpsg/2015+EngRun+Reconstruction+Passes
I'm seeing smaller output LCIO files than pass0, by a factor of 2 or more.
Anyone know if this is expected?
I set one canonical run, 5772, whose LCIO and DST outputs will be going to disk in addition to tape.
Any more? (Calibration runs' outputs are going to disk too).
-Nathan
On Jun 8, 2015, at 21:14, Graham, Mathew Thomas <[log in to unmask]> wrote:
> We are ready and the release is 3.3.2-1 here:
>
> http://srs.slac.stanford.edu/nexus/service/local/artifact/maven/redire
> ct?r=lcsim-maven2-releases&g=org.hps&a=hps-distribution&v=3.3.2-1&e=ja
> r&c=bin
>
>
>> On Jun 8, 2015, at 6:07 PM, Nathan Baltzell <[log in to unmask]> wrote:
>>
>> Hi Everyone,
>>
>> There was discussion late last week that concluded we weren't ready for pass1.
>> That included some idea that there was progress to be made on data
>> and simulations in order to have some commensurate set. So, are we
>> now ready? Should we start
>> pass1 or wait?
>>
>> -Nathan
>>
>> #####################################################################
>> ###
>> Use REPLY-ALL to reply to list
>>
>> To unsubscribe from the HPS-SOFTWARE list, click the following link:
>> https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1
>
########################################################################
Use REPLY-ALL to reply to list
To unsubscribe from the HPS-SOFTWARE list, click the following link:
https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1
########################################################################
Use REPLY-ALL to reply to list
To unsubscribe from the HPS-SOFTWARE list, click the following link:
https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1
|