I’m good with that too.
> On Sep 19, 2015, at 9:52 PM, Sho Uemura <[log in to unmask]> wrote:
>
> Sounds good to me.
>
> On Sat, 19 Sep 2015, Nathan Baltzell wrote:
>
>> Then I suggest to call pass2 done, and only fix things where people express
>> desire for certain runs that are missing. Or we can do another pass (e.g.
>> pass2ecal) just for these extra runs, or a whole nother pass2a. With such
>> big holes, yet unknown problems, and mixing jars, I don't think there's
>> sufficient value in the work necessary to shore up pass2.
>>
>>
>>
>> On Sep 19, 2015, at 10:15 PM, Sho Uemura <[log in to unmask]> wrote:
>>
>>> That error is caused by a bug - if there were no "bias good" periods in/overlapping a run, the conditions system throws an exception which is not caught in the event flagger code.
>>>
>>> This was fixed in trunk, but too late for the pass2 release.
>>>
>>> If I understand this problem, it only affects two types of runs:
>>>
>>> 1. runs taken before 5/5/15, when SVT HV was added to MYA (up to 5387).
>>>
>>> 2. runs where SVT bias was never on - mostly junk runs, but I think there are a few ECal pedestal/calib runs in this category (5402, 5745, 5747, 5748).
>>>
>>> I don't think SVT people care much about any of these runs. But ECal probably cares.
>>>
>>> I could apply the necessary fix to the 5.4.0 release, and the patched jar could be used to reprocess these runs.
>>>
>>> On Sat, 19 Sep 2015, Nathan Baltzell wrote:
>>>
>>>> Many failures may have been related to this error:
>>>> No conditions were found with key: svt_bias_constants
>>>>
>>>> Here's a list of runs with that log message:
>>>> /work/hallb/hps/data/engrun2015/pass2fail/svt_bias_constants_runs.txt
>>>>
>>>> -Nathan
>>>>
>>>> ########################################################################
>>>> Use REPLY-ALL to reply to list
>>>>
>>>> To unsubscribe from the HPS-SOFTWARE list, click the following link:
>>>> https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1
>>>>
>>
>> ########################################################################
>> Use REPLY-ALL to reply to list
>>
>> To unsubscribe from the HPS-SOFTWARE list, click the following link:
>> https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1
>>
>
> ########################################################################
> Use REPLY-ALL to reply to list
>
> To unsubscribe from the HPS-SOFTWARE list, click the following link:
> https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1
########################################################################
Use REPLY-ALL to reply to list
To unsubscribe from the HPS-SOFTWARE list, click the following link:
https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1
|