 |
 |
Okay, here's some sections of the flange at different values of Z; center of viewer is (0,0) I think - I have no idea what I'm doing but I managed to get SLIC to display the geometry. Looking at the Z=150 view, it looks like the photon hole is ~15 mm (somewhat more than one crystal width) from the center, where you'd want it to be at (150 cm)*(30 mrad) = 45 mm? On Tue, 13 Nov 2012, Sho Uemura wrote: > Can't verify, because I don't have any tool that can visualize the > tessellated solid. This is the same flange (same global coordinates) that has > been used for every SLIC simulation of electron running - beyond that I don't > really know. > > On Tue, 13 Nov 2012, Maruyama, Takashi wrote: > >> If I send photons and beam-energy electrons at 30 mrad from the target, >> photons would go through the photon hole and electrons the beam notch in >> the Ecal vac chamber. Is this correct? >> >> -----Original Message----- >> From: [log in to unmask] >> [mailto:[log in to unmask]] On Behalf Of Sho Uemura >> Sent: Tuesday, November 13, 2012 2:26 PM >> To: hps-software >> Subject: new detector geometry for proposal >> >> HPS-Proposal2014-v2 is the detector we're using. I've just corrected the >> ECal position and added the electron flange. >> >> You should update hps-detectors from CVS and rerun SLIC if you have MC data >> from the following detectors: >> >> HPS-Prime-Nominal-v2 >> HPS-Proposal2014-v1 >> HPS-Proposal2014-v2 >> >> ######################################################################## >> Use REPLY-ALL to reply to list >> >> To unsubscribe from the HPS-SOFTWARE list, click the following link: >> https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1 >> >> ######################################################################## >> Use REPLY-ALL to reply to list >> >> To unsubscribe from the HPS-SOFTWARE list, click the following link: >> https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1 >> > > ######################################################################## > Use REPLY-ALL to reply to list > > To unsubscribe from the HPS-SOFTWARE list, click the following link: > https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1 > ######################################################################## Use REPLY-ALL to reply to list To unsubscribe from the HPS-SOFTWARE list, click the following link: https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1