 |
 |
CMake_version = "2.8.12.2" ILCUTIL_version = "v01-00" XercesC_version = "3.1.1" LCIO_version = "v02-04-03" Geant4_version = "9.6.p01" HepPDT_version = "3.04.01" GDML_version = "v03-00-02" LCDD_version = "v03-03-04" SLIC_version = "v03-01-04" On Fri, 26 Sep 2014, McCormick, Jeremy I. wrote: > I will give this a look? > > What version of SLIC are you using, exactly? Can you dump the versions from the relevant versions.py file and send them please? > > On Sep 26, 2014, at 12:13 PM, Sho Uemura <[log in to unmask]<mailto:[log in to unmask]>> wrote: > > I see the same thing - a current build of SLIC will not load the v3 geometry, and complains about the volume split_0. This is a tessellated volume (ECal vacuum flange) which was replaced with Geant4 primitives starting in v4. I think that at some point SLIC stopped supporting tessellated volumes, but Jeremy or Norman should confirm. > > The v3 detectors are the only detectors in the hps-java trunk that use a tessellated volume. Data previously generated by SLIC using the v3 detectors can still be run through hps-java. > > Suggestion: The data on tape uses the v6 detector. Maybe you don't need to run v3. > > On Fri, 26 Sep 2014, Luca Colaneri wrote: > > Hi guys, > > I've been running SLIC on the same stdhep files with V7, V8 and V3 geometries, to check for the differences and see If I can use the data on tape to set the calibration point or we need to rerun slic wit the newest geometry. I had n problems with V7 and V8, but with V3 i get the error you can read in the attached screenshot. > Any suggestion? > > L. > > ######################################################################## > Use REPLY-ALL to reply to list > > To unsubscribe from the HPS-SOFTWARE list, click the following link: > https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1 > > > ######################################################################## > Use REPLY-ALL to reply to list > > To unsubscribe from the HPS-SOFTWARE list, click the following link: > https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1 > > > ######################################################################## > Use REPLY-ALL to reply to list > > To unsubscribe from the HPS-SOFTWARE list, click the following link: > https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1 > ######################################################################## Use REPLY-ALL to reply to list To unsubscribe from the HPS-SOFTWARE list, click the following link: https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1