I see the same thing - a current build of SLIC will not load the v3 geometry, and complains about the volume split_0. This is a tessellated volume (ECal vacuum flange) which was replaced with Geant4 primitives starting in v4. I think that at some point SLIC stopped supporting tessellated volumes, but Jeremy or Norman should confirm.

The v3 detectors are the only detectors in the hps-java trunk that use a tessellated volume. Data previously generated by SLIC using the v3 detectors can still be run through hps-java.

Suggestion: The data on tape uses the v6 detector. Maybe you don't need to run v3.

On Fri, 26 Sep 2014, Luca Colaneri wrote:

Hi guys,

I've been running SLIC on the same stdhep files with V7, V8 and V3 geometries, to check for the differences and see If I can use the data on tape to set the calibration point or we need to rerun slic wit the newest geometry. I had n problems with V7 and V8, but with V3 i get the error you can read in the attached screenshot.
Any suggestion?

L.

########################################################################
Use REPLY-ALL to reply to list

To unsubscribe from the HPS-SOFTWARE list, click the following link:
https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1

########################################################################
Use REPLY-ALL to reply to list

To unsubscribe from the HPS-SOFTWARE list, click the following link:
https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1