Hello All, Pass1 started with the calibration runs last night. Documentation is going here: https://confluence.slac.stanford.edu/display/hpsg/2015+EngRun+Reconstruction+Passes I’m seeing smaller output LCIO files than pass0, by a factor of 2 or more. Anyone know if this is expected? I set one canonical run, 5772, whose LCIO and DST outputs will be going to disk in addition to tape. Any more? (Calibration runs’ outputs are going to disk too). -Nathan On Jun 8, 2015, at 21:14, Graham, Mathew Thomas <[log in to unmask]> wrote: > We are ready and the release is 3.3.2-1 here: > > http://srs.slac.stanford.edu/nexus/service/local/artifact/maven/redirect?r=lcsim-maven2-releases&g=org.hps&a=hps-distribution&v=3.3.2-1&e=jar&c=bin > > >> On Jun 8, 2015, at 6:07 PM, Nathan Baltzell <[log in to unmask]> wrote: >> >> Hi Everyone, >> >> There was discussion late last week that concluded we weren't ready for pass1. >> That included some idea that there was progress to be made on data and simulations >> in order to have some commensurate set. So, are we now ready? Should we start >> pass1 or wait? >> >> -Nathan >> >> ######################################################################## >> Use REPLY-ALL to reply to list >> >> To unsubscribe from the HPS-SOFTWARE list, click the following link: >> https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1 > ######################################################################## Use REPLY-ALL to reply to list To unsubscribe from the HPS-SOFTWARE list, click the following link: https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1