Hi Norman, They’re on tape (you can see filesize in the stub files). I’m jgetting the calibration DSTs and LCIOs to the work disk (submission scripts weren’t updated yet). -Nathan On Jun 9, 2015, at 11:11, Graf, Norman A. <[log in to unmask]> wrote: > Good Morning Nathan, > Thanks! What output lcio files are you looking at? > I'm not yet seeing any files on disk at > > /work/hallb/hps/data/engrun2015/pass1/recon/ > > Norman > > -----Original Message----- > From: [log in to unmask] [mailto:[log in to unmask]] On Behalf Of Nathan Baltzell > Sent: Tuesday, June 09, 2015 6:26 AM > To: hps-software > Subject: Re: pass1 > > Hello All, > > Pass1 started with the calibration runs last night. Documentation is going here: > > https://confluence.slac.stanford.edu/display/hpsg/2015+EngRun+Reconstruction+Passes > > I'm seeing smaller output LCIO files than pass0, by a factor of 2 or more. > Anyone know if this is expected? > > I set one canonical run, 5772, whose LCIO and DST outputs will be going to disk in addition to tape. > Any more? (Calibration runs' outputs are going to disk too). > > -Nathan > > > On Jun 8, 2015, at 21:14, Graham, Mathew Thomas <[log in to unmask]> wrote: > >> We are ready and the release is 3.3.2-1 here: >> >> http://srs.slac.stanford.edu/nexus/service/local/artifact/maven/redire >> ct?r=lcsim-maven2-releases&g=org.hps&a=hps-distribution&v=3.3.2-1&e=ja >> r&c=bin >> >> >>> On Jun 8, 2015, at 6:07 PM, Nathan Baltzell <[log in to unmask]> wrote: >>> >>> Hi Everyone, >>> >>> There was discussion late last week that concluded we weren't ready for pass1. >>> That included some idea that there was progress to be made on data >>> and simulations in order to have some commensurate set. So, are we >>> now ready? Should we start >>> pass1 or wait? >>> >>> -Nathan >>> >>> ##################################################################### >>> ### >>> Use REPLY-ALL to reply to list >>> >>> To unsubscribe from the HPS-SOFTWARE list, click the following link: >>> https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1 >> > > ######################################################################## > Use REPLY-ALL to reply to list > > To unsubscribe from the HPS-SOFTWARE list, click the following link: > https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1 ######################################################################## Use REPLY-ALL to reply to list To unsubscribe from the HPS-SOFTWARE list, click the following link: https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1