 |
 |
Sounds good to me. On Sat, 19 Sep 2015, Nathan Baltzell wrote: > Then I suggest to call pass2 done, and only fix things where people express > desire for certain runs that are missing. Or we can do another pass (e.g. > pass2ecal) just for these extra runs, or a whole nother pass2a. With such > big holes, yet unknown problems, and mixing jars, I don't think there's > sufficient value in the work necessary to shore up pass2. > > > > On Sep 19, 2015, at 10:15 PM, Sho Uemura <[log in to unmask]> wrote: > >> That error is caused by a bug - if there were no "bias good" periods in/overlapping a run, the conditions system throws an exception which is not caught in the event flagger code. >> >> This was fixed in trunk, but too late for the pass2 release. >> >> If I understand this problem, it only affects two types of runs: >> >> 1. runs taken before 5/5/15, when SVT HV was added to MYA (up to 5387). >> >> 2. runs where SVT bias was never on - mostly junk runs, but I think there are a few ECal pedestal/calib runs in this category (5402, 5745, 5747, 5748). >> >> I don't think SVT people care much about any of these runs. But ECal probably cares. >> >> I could apply the necessary fix to the 5.4.0 release, and the patched jar could be used to reprocess these runs. >> >> On Sat, 19 Sep 2015, Nathan Baltzell wrote: >> >>> Many failures may have been related to this error: >>> No conditions were found with key: svt_bias_constants >>> >>> Here's a list of runs with that log message: >>> /work/hallb/hps/data/engrun2015/pass2fail/svt_bias_constants_runs.txt >>> >>> -Nathan >>> >>> ######################################################################## >>> Use REPLY-ALL to reply to list >>> >>> To unsubscribe from the HPS-SOFTWARE list, click the following link: >>> https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1 >>> > > ######################################################################## > Use REPLY-ALL to reply to list > > To unsubscribe from the HPS-SOFTWARE list, click the following link: > https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1 > ######################################################################## Use REPLY-ALL to reply to list To unsubscribe from the HPS-SOFTWARE list, click the following link: https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1