Can you check the lcdd file to make sure the correct opening angle was
picked up?
On Oct 20, 2016 9:04 AM, "Bradley T Yale" <[log in to unmask]> wrote:
> The .lcdd I used was built from the compact.xml.
> ------------------------------
> *From:* Alessandra Filippi <[log in to unmask]>
> *Sent:* Thursday, October 20, 2016 3:46:50 AM
> *To:* Bradley T Yale
> *Cc:* [log in to unmask]
> *Subject:* Re: Readout Error with new detector
>
> Hi Bradley,
> to my experience this is the typical error when you have a mismatch of the
> geometries used for the slic generation, readout and the reconstruction
> Are you sure you are running slic usng the proper lcdd file? (also check
> that the geometry names are everywhere consistent, in .lcdd and
> compact.xml files).
> Once you disable reading from the DB the svt geometry the run number you
> insert is not really useful.
> cheers
> Alessandra
>
>
>
> On Thu, 20 Oct 2016, Bradley T Yale wrote:
>
> >
> > Running readout on A's with the new 1.5mm detector
> ('HPS-EngRun2015-1_5mm-v5-0-fieldmap'),
> >
> > this error occurs:
> >
> >
> > java.lang.RuntimeException: Distance is outside of sensor by more than
> 0.001. Distance =
> > 0.45499278811630983. If this is an isolated event, then perhaps
> DISTANCE_ERROR_THRESHOLD
> > must be increased in CDFSiSensorSim
> >
> >
> > It happens when setting either run 5412 (1.5mm) or 5772 in the java
> command:
> >
> >
> > java -DdisableSvtAlignmentConstants -XX:+UseSerialGC -Xmx500m -jar
> ${hps-java}
> >
> > -r /org/hps/steering/readout/EngineeringRun2015TrigPairs1_Pass2.lcsim
> >
> > -i in.slcio -DoutputFile=out -Ddetector=HPS-EngRun2015-1_5mm-v5-0-fieldmap
> -Drun=5412
> >
> >
> > Did anything change lately that could cause this?
> >
> >
> >
> > ____________________________________________________________
> ______________________________
> >
> > Use REPLY-ALL to reply to list
> >
> > To unsubscribe from the HPS-SOFTWARE list, click the following link:
> > https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1
> >
> >
> >
>
> ------------------------------
>
> Use REPLY-ALL to reply to list
>
> To unsubscribe from the HPS-SOFTWARE list, click the following link:
> https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1
>
########################################################################
Use REPLY-ALL to reply to list
To unsubscribe from the HPS-SOFTWARE list, click the following link:
https://listserv.slac.stanford.edu/cgi-bin/wa?SUBED1=HPS-SOFTWARE&A=1
